Table of Contents
Advertisement
Quick Links
WINDOW CLEANING ROBOT
QUICK START GUIDE
ATTACH THE CLEANING PAD
Attach a clean pad to the device. Make sure it is
smooth and tight.
FILL IN CLEANING AGENT
Open the pot of the water tank, fill in an appro-
priate amount of pure water or special glass
cleaner. If necessary, use the enclosed filling aid.
Close the water tank tightly again.
CONNECT TO THE POWER
Connect the adapter and the power plug as
shown in the sequence below. Finally, insert the
plug into the power socket.
Caution!
Improper connection can
cause damage to the device.
ATTACH THE SAFETY ROPE
The safety rope is intended for use at high-rise
windows. Check the rope for damage before use.
Then attach it to a solid object.
START CLEANING
To start the cleaning process, place the device in the
center of the window.
Press and hold the power button for 3 seconds to
turn on the device. Check that the device is securely
attached to the glass.
Briefly press the power button again to start the
cleaning process.
Press and hold
the power button for
more than 1 second
When the cleaning process is finished, the device
returns to the starting point by itself.
Grasp the device and press the power button for 3
seconds until the device turns off.
Remove the unit from the glass, check the degree of
soiling of the pad and wheels, and clean them if
necessary before further use. Top up with water if
necessary.
NOTE & CAUTION
Note: For heavily soiled windows, it is recom-
mended to spray some window cleaner on the
window before use. Replace the cleaning pad in
time once it gets dirty, and run the device the
second pass with the water spray off to remove
streaks, if any.
Caution!
Do not leave the device on the window longer
than necessary to avoid damage. Be sure to hold
the device tightly when you turn it off to avoid
accidental dropping.
Advertisement
Table of Contents
Related Manuals for Hutt W8
Summary of Contents for Hutt W8
- Page 1 WINDOW CLEANING ROBOT QUICK START GUIDE ATTACH THE CLEANING PAD CONNECT TO THE POWER START CLEANING To start the cleaning process, place the device in the Connect the adapter and the power plug as Attach a clean pad to the device. Make sure it is center of the window.
- Page 2 3.When working on exterior windows, place warning sign under the operating surface. If you wish to be a HUTT brand product trial officer, you may contact us for the latest 4.If you are not sure whether the robot is applicable to your windows, place protective new product trail plan.
Need help?
Do you have a question about the W8 and is the answer not in the manual?
Questions and answers
I get the edge sensor alarm. I wiped them with a Qtip. Maybe they got wet, can I hairdry them. How do I reset device?
To reset the Hutt W8 device after an edge sensor alarm, clean the sensors and ensure there is no dust or debris obstructing them. If the issue persists, restart the device by turning it off and on again.
It is not mentioned whether using a hairdryer to dry the sensors is safe.
This answer is automatically generated