Important Notes Please read this Installation Guide carefully or contact the Customer Care for any queries regarding installation. Installation is recommended to be performed by a professional to avoid any additional service charges that may cause due to improper product installation. We constantly revise the contents of this Installation Guide and update our products to improve the quality and performance without any prior notice.
What's in the Box Mounting Plate Outdoor Unit Indoor Unit Gasket Keys Latch Strike Plate and Box MF Cards Hex wrench Screw A Screw B Screw C Screw D Spindle Spindle Spindle B Door Thickness Screw C 30 to 38 mm 56 mm 20 mm 25 mm...
Installation Diagram Outdoor Unit Door Gasket Gasket Keys Indoor Unit Mounting Plate Battery Battery Cover (not included) Spindle Screw B Screw A Latch Screw C Strike Plate and Box Screw D Installation Procedure Door Properties Check the door thickness After measuring the door’s thickness, select the proper Spindle and Screw length. For details, please refer to the table contents of Page 1.
Page 5
Latch StrikePlate StrikePlate Latch Right Inward Left Inward Latch StrikePlate StrikePlate Latch Left Outward Right Outward User Location Change the handle direction (if needed) Use the hex wrench to remove the screw of handle. Take the handle out from the lock. Change the handle direction and replace.
Drilling Holes on the Door Place the Installation Template at the desired handle height. Mark for the holes to be drilled and drill the marked places. Center line of handle Desired handle height Installing Latch Adjust the backset of the lock. (if needed) Secure the Latch with the Screw A.
Installing Outdoor Unit Attach the Gasket to the Outdoor Unit. Insert Spindle into the clutch. Attach the Outdoor unit to the door by inserting the cable through the drilled holes. Clutch c orrect p osition: T he triangle must be vertically centered. Installing Mounting Plate and Gasket Attach the Mounting Plate to the Gasket and route the cable through the hole.
Installing Indoor Unit Connect the cable to the port on the Indoor Unit. Place the Indoor Unit properly on the Mounting Plate. Then use Screw B & Screw D to secure the Indoor Unit. Screws Installing Battery and Cover Insert four Alkaline AA batteries and cover them with a battery cover.
Installing Strike Plate and Box Make sure that the Strike Box is aligned with the latch bolt. Then, use the Installation Template to drill holes. Align the Strike Plate and Box with the drilled holes and secure them with Screw A. Screws A 2(mm) (10/127")
Page 10
Warning: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.