Rayrun TT12 Quick Start Manual

Smart & Remote Control
Single Color LED Controller
Model: TT12 (W/Z/B)
Tuya Smart
RF Remote
High Power
Overheat Protection
Compact Size
12V/24V voltage
2. LED output
Connect LED fixtures positive to the cable marked
with '+' and negative to the cable marked with '-'.
Please make sure the LED rated voltage is same as the
power supply and the maximum load current is below
the controller rated current.
CAUTION! The controller will be permanently
damaged if output cables short circuited. Please ensure
the cables are well insulated to each other.
3. Work status indicator (optional)
This indicator shows all working status of the
controller. It displays different events as following:
Steady on: Remote and Tuya smart mode.
Flash twice: Tuya not connected.
Flash 3 times: Over heat protection.
Blink: New command received.
Long single blink: Reach brightness limit.
4. Wiring diagram
To 110/230
12-24V DC output
AC power Power supply
12-24V DC
TT12 LED
LED Strips
Controller
12-24V Driving
LED Controller
2
Introduction
TT12 LED controller is designed to drive constant
voltage single color LED products in voltage range of
DC12-24V. It can be controlled by Tuya smart app or by a
handheld RF remote controller. User can setup LED
brightness with the rich function on the Tuya smart app or
from the easy operation remote controller.
Terminal & Size
1
1. Power supply input
Connect positive power to the cable marked with '+'
and negative to the cable marked with '-'. The controller
can accept DC power from 12V to 24V, the output is PWM
driving signal with same voltage level as the power supply,
so please make sure the LED rated voltage is same as the
power supply.
Functions
7
5. Turn ON / OFF
Press to turn on or off the output. The controller will
memorize the on/off status and will restore to the previous
status on the next power on. Please use remote controller to
turn on the unit if it was switched to off status before power
cut.
6. Brightness adjust
Press and
Hold press these two keys will adjust the LED brightness
smoothly.
2
60mm
3 2
5
6
key to adjust brightness sequentially.
20.5mm
1 1
3