Arcam Delta 60 Handbook page 7

Delta 60 integrated amplifier handbook
Mono
The amplifier is in its normal stereo mode when the mono
button is out. In this position, the left and right input signals are amplified
independently to feed the corresponding loudspeaker outputs. When the
mono button is pushed in the left and right signals are mixed together and
the combined signal is routed to both loudspeakers. This is particularly
useful when listening to mono records or tapes (as much low frequency
out-of-phase rumble can be eliminated) or to remove excessive hiss from
FM broadcasts. It is also invaluable for checking speaker phasing in a stereo
hi fi system.
Tape 2 recording/monitoring
All sources, disc, CD, tuner and Tape I can be recorded via the
Tape 2 connections. To record an input select the required source and set
your recorder into the record mode. If your tape machine is a three head
type suitable for A/B monitoring then pressing the Tape 2 switch will allow
off tape monitoring.
Playback
Press the Tape 2 switch and set your recorder into the
playback mode.
Phones
The headphone socket will accept any headphones fitted with
a standard quarter inch (6.35mm) stereo jack plug. The headphones may
be operated in parallel with the loudspeaker outlets, or not, as you wish
(see Loudspeakers above).
Tape recording
The Delta 60 has facilities for two tape recorders. The Tape
I input is most suitable for use with two head tape recorders and video
recorders. The Tape 2 input, in addition to the above, is ideally suited
for use with three head tape machines, where tape monitoring
is a requirement.
Tape 1 recording
To record an input simply select the required source - either
Disc, CD or Tuner - and set your recorder into its recording mode. Note,
it is not possible to record signals from the Tape 2 source to Tape 1.
Playback
Depress the Tape 1 switch and set your recorder into the
playback mode.