Table of Contents
Advertisement
I
FIGURE 11.
FINAL ASSEMBLY OF MOWER (Hardware F)
1. If plastic plug is needed and is not already
assembled, insert plastic plug into hole in the top
rear of the deck by slipping one end of plug into
hole, then pressing down on the other end of plug.
Use a soft hammer if necessary.
2. Place hub caps in position against the inner hub
of the wheel. Press firmly around the center por¬
tion of hub cap in a circular motion, similar to in¬
stalling a lid on a round, plastic container. See
-figure 11. The hub caps are flexible and will snap
over the
3
V
2
" diameter wheel hubs.
3. Make certain all nuts and bolts are tightened
securely.
4. Be certain to charge the battery as instructed in
"Before Starting" section under Operation. Read
instructions carefully.
GRASS CATCHER ASSEMBLY (Hardware C)
1. Join the rear frame and front frame assembly as
-shown in figure 12.
NOTE: Make certain the grass bag is turned right side
out before assembling (warning label will be on the
outside).
2. Place the frame inside the grass catcher bag. The
bottom of the grass bag is black plastic. The hooks
on the front frame go toward the top of the bag.
-See figure 13.
3. Secure front of bag to frame by working the plastic
—channels on bag over frame. See figure 14.
10
Advertisement
Table of Contents
