Electrical Connection - Tricity Bendix TM 550 Operating & Installation Instructions Manual

ELECTRICAL CONNECTION
/f\ Any electrical work required to install this appliance
should be carried out by a qualified electrician or
competent person.
WARNING - THIS APPLIANCE MUST
BE EARTHED
Before switching on make sure the electricity supply voltage
is the same as that indicated on the appliance rating plate.
The rating plate is located on the back panel of your tumble
dryer.
CHANGING A FUSE
Your tumble dryer will be fitted with one of two plugs. When
replacing the fuse, always use ASTA approved 13A fuses to
British Standard 1362.
Type 1: Prise out the fuse cover (A) with fuse (B).
Change the fuse and refit both to the plug.
Important
- The fuse cover must be refitted when changing a
fuse. If the fuse cover is lost, the plug should not be used
until a correct replacement is fitted. Replacements are
identified by the colour insert or the colour embossed in
words on the base of the plug. They are available from most
electrical retail shops.
Type 2: Prise up the hinged fuse cover (A) as shown.
Replace the fuse and press the cover back into place.
FITTING A REPLACEMENT PLUG
Should the plug need to be replaced for any reason the wires
in the mains lead are coloured in accordance with the
following code:
Blue - Neutral 'N'
Brown - Live 'L'
Green and Yellow - Earth 'E'
The GREEN & YELLOW wire must be connected to the
terminal in the plu^^hich is marked with the letter 'E' or by
the earth symbol or coloured green or green and yellow.
The BLUE wire must be connected to the terminal marked
with the letter 'N' or coloured black.
The BROWN wire must be connected to the terminal that is
marked with the letter 'L' or coloured red.
/f\ A cut off plug inserted into a 13 amp socket is a
serious safety (shock) hazard. Ensure that the cut
off plug is disposed of safely.
13