Panasonic OmniVision PVQ-V200 Operating Instructions Manual page 6

OneTimeVCR Setup
When VCR is turned on the first time, Process of Setup
Turn the TV and VCR on.
Press POWER*.
Set TV Channel to CH 3.
* If using AV Cable connection, set TV
to Video instead of channel. (See
connection a) on page 4.)
Display SELECT LANGUAGE.
This display appears tor first time setup
only.
Select the language.
SELECT LANGUAGE for English
OPRIMIA CH Y : ESPANOL
. VCR/TV : FRANCAIS for Spanish
(ESPANOL)
TO CHANGE VCR'S OUTPUT
'IF YOU PUSH ACTION KEY, —
VCR' s OUTPUT CH swiTcHes| When using connection b) (see
oa page 4), tune TV to VCR's output
Y) Press ACTION channel. :
PLEASE TUNE YOUR If there is beat or noise on CH3
TUNE YOUR TV T ,
a: : i = al | change VCR's output channel to CH4
by pressing ACTION twice.
After 3 seconds
+ Always tune TV to this channel to monitor the VCR.
e If you used audio/video jack connection, tune the TV to its video input. |
* If wrong language is set, do "Reset All VCR Memory Functions" SS PE Ó
steps on page 24. ba seer È
Start Ch | Auto Set
CHANNEL/CLOCK AUTO SET | Srl Clock Auto Sct,
CONNECT ANTENNA CABLE à Mei
AND IF YOU USE A CABLE HA.
BOX, TUNE IT TO YOUR eS
LOCAL PBS CH THEN...
0)
O
I
4TRACKING)»
PLEASE PUSH CH UP KEY
y
| 'CH AUTO SET PROCEEDING |
| ~~ AUTO CLOCK SET 7 |
g
PROCEEDING `
J (Setup completed) (Setup incomplete)
z | Press CH A to exit.
1/ 4/ 2000 TUE 12:00PM g elf your area observes
DST :ON CH Š DST (daylight saving
v
incorrect; do the
l
AUTO CLOCK SET "Time Zone Adjust" IS INCOMPLETE
COMPLETED steps on page 23.
PUSH ACTION TO SET CLOCK
END : PUSH CH UP KEY
e If the displayed time is not correct,
do the "Clock" section on page 22.
6 For assistance, call 1-800-211-PANA(7262).