Synchro Recording - Kenwood KX-5550 Instruction Manual

Synchro recording
By connecting this unit with a KENWOOD CXS type amplifier (receiver! with a SYSTEM CONTROL jack and a KENWOOD turntable
with a SYSTEM CONTROL jack using system control cords, recording on this unit and playback on the turntable can be start-
I
Set the input selector switches of the am¬
plifier for the PHONO source.
2 Place an analog disc on the turntable.
3 Make preparations for recording.
(T) Insert a tape.
(f) Set the tape trans¬
port direction.
(3)
Select the side(s) to
be recorded onto.
V
i
—=0
. Two-sida recording
.. One-side recording
(4)
Select the Dolby NR mode.
DOLBY NR | B | -* DOLBY NR
OFF*-
5]~|
4 Activate the auto-bias setting.
Recording is possible even when the auto-bias setting
is omitted.
The optimum bias is set in about 45 seconds, after which
the deck enters the stop mode.
For the bias preset operation, refer to page 13.
0 Adjust the recording level.
(T) Start playing an analog disc.
PLAV/CUT
K
© Enter the record-pause mode.
._REC/ARM
Press both keys at
the same time.
(3)
Adjust the recording balance and recording level.
Adjust so that these segments
light at times,
(4)
Stop playing the analog disc.
PLAY/CUT
1 The cassette deck returns
to the stop mode.
6
Set the record-pause mode.
7 Start playing the analog disc.
• Recording starts at this moment.
REE/Afllil „
4J
PL.
isc.-
AY/CUT
.n_1
When the turntable has completed the play, I f
the deck stops recording and enters the stop mode.
To stop recording in the middle
Press the [ PLAY/CUT [ key of the turntable.
• If the stop key of the cassette deck is pressed, the cassette
deck enters the stop mode but the turntable does not.
16 KX-5550 (En)