Selecting Offset Frequency - Kenwood TM-261A Instruction Manual

Select a receive frequency.
Select an offset frequency.
Select an offset direction.
Activate theTone function, if necessary.
Select a Tone frequency, if necessary.
Press microphone [PTT].
FLOW CHART FOR REPEATER ACCESS
@ Selecting Offset Frequency
Select how much the transmit frequency will be offset
from the receive frequency.
1 Press [F] (1s) to access Menu A.
2 Select "O.S" {page 17}.
¢ The current offset frequency appears.
'a MENU j=j |
| 4
3 Select the appropriate offset frequency within
20 MHz of the receive frequency.
¢ The setting for "F.S" (Menu A) determines the
frequency steps used while you are selecting the
offset frequency.
¢ The minimum selectable offset frequency is dependent
on the current frequency step.
4 Press [F] or microphone [PTT] to exit Menu A.
Note: Selections must be made within approximately 10 seconds or
the previous mode is restored.