Related Manuals for MARELUX Apollo III Strobe
Summary of Contents for MARELUX Apollo III Strobe
- Page 1 Apollo III Strobe User Manual Please read this user manual carefully before starting to use the product, and use the product properly based on the thorough understanding of this user manual.
-
Page 2: Package Contents
Package Contents Apollo III Strobe Battery *3 Dome Diffuser Protective Cover Mounting Ball O-Ring*2... -
Page 3: Product Features
Product Features 1. Support TTL, Olympus RC, HSS. 2. Support MTL mode with continuous flashes. 3. Wireless Trigger: with two fisheye wireless signal sensors covering 100 °, support M, MTL and M-HSS modes. 4. Fiber Trigger: with one fiber port that supports M, TTL, Olympus RC, M-HSS and MTL modes 5. -
Page 4: Parts Illustration
Parts Illustration Battery Cap Optical Signal Receiver Mode Knob Light Level Control Knob Strobe Indicator Light Fiber Port... -
Page 5: Battery Installation
Battery Installation Make sure that the mode knob is in the OFF position Remove the Battery Cap by slowly rotating counterclockwise. Insert three 18650 lithium batteries with the polarity shown in the battery compartment. (Please note that this strobe requires three 18650 lithium batteries with a discharge current greater than 20A and a voltage of 3.7V. -
Page 6: Operation
Operation Mode Knob OFF Turns the power off. Switch mode knob to [OFF] when you don’t use the strobe. TEST In this mode, you can test the working status of the strobe. Press the mode knob to trigger the strobe. M Switch to M mode to set light amount to Manual. - Page 7 Target Light In modes other than the test mode, press the mode knob to turn on the target light. The target light has two colors, red and white, and each color has two brightness levels. Press the mode knob to change the color and brightness level. Wireless Trigger Mode To use the wireless trigger mode, the Lumilink optical transmitter is required as the signal transmitter.
- Page 8 Strobe Indicator Light The emission color of the strobe indicator light will change depending on the remaining battery level. Emission colors are shown in the table below. Remaining Battery Level Emission color 75~100% Green 50~75% Blue 25~50% Purple 0~25% When the strobe indicator light is in a low battery state with a red light, please refrain from using the flash function to avoid damaging the battery.
-
Page 9: Protective Cover Installation
Protective Cover Installation Align the protective cover with the strobe as shown in the diagram. Rotate the screw clockwise as shown in the diagram. - Page 10 Mounting Ball Installation Install the mounting ball with two screws in the direction shown in the diagram. Dome Diffuser Installation Install the Dome Diffuser in the direction shown in the diagram.
-
Page 11: Maintenance And Storage
Maintenance And Storage 1. After diving, make sure the strobe is locked and sealed, wash the strobe body with fresh water. 2. When immersed with fresh water, push each button few times, thus can help to let salt and sand go out. 3. -
Page 12: Warranty
Warranty 1. Marelux provides 2 years warranty for its housing body, cable (such as fiber cable and HDMI cable), and 1 year warranty for electronic parts and components made of silicon, rubber and plastic. 2. Marelux will keep components and parts for repair and maintenance in storage for 5 years after EOL of each model. - Page 13 ⚫ Products will lose warranty immediately after unauthorized repair or modification. ⚫ The warranty terms above are made for Marelux customers to conduct free warranty service and repair and have no restriction to any legal rights that customers shall possess.
Need help?
Do you have a question about the Apollo III Strobe and is the answer not in the manual?
Questions and answers