LG SDWB24W3 Owner's Manual page 23

Error Code Possible Cause and Solution
Water supply line is kinked
IE
under dishwasher.
• Feed the drain and water
supply hoses through the hole
under the sink. Then gradually
slide the dishwasher into the
cabinet while pulling on the
hoses under the sink to take up
any slack. This helps avoid
kinking the hoses or trapping
them beneath the dishwasher.
House water supply is not turned
on.
• Turn the water faucet on.
Replacing Handle
NOTE
• Only available on applicable models
(SDWB24W3).
• The handle is an accessory part and can be
purchased separately.
1
Screws for disassembly and assembly are
located on the underside of the handle.
2
To remove the handle, loosen the screws
using a hex wrench. (H3/32" (H2.4 mm))
CAUTION
• The screws are tilted about 15 degrees from the
plane of the door. Take care not to scratch the
surface of the door when disassembling and
assembling the handle.
3
Fit the new handle over the mounting
fasteners as shown and tighten the set screws
to secure it in place.
CAUTION
• Tighten the screw with a torque of 20-40 kgf*cm.
• When assembling or disassembling the handle,
grasp the handle firmly to avoid dropping it.
• Make sure that the set screws are in place and
the handle footprints at the ends of the handle
are aligned correctly over the mounting
fasteners on the door. The set screws should be
loose enough to allow the handle footprints to
slide down into place over the mounting
fasteners on the door.
• Make sure that there is not a gap between the
door and handle after assembling the handle.
INSTALLATION 23