Advertisement
2.
The back of the housing will be compressed by pressure
underwater or after air travel. Rotate the latch fully to
break the seal of the housing. Do not use metal objects or
tools to pry the back open.
3.
Lift the latch up and away from the housing.
4.
Carefully open the housing back.
Installing the Camera
1.
Remove any lanyard, neck strap, or accessory attached
to the camera.
2.
Place the camera into the front of the housing with the
lens centered in the lens port.
3.
Make sure the camera is sitting flat in the housing and
flush to the front support ribs.
Support rib
Closing the Housing
1.
Apply a very thin, even layer of lubricant to the exposed
portion of the o-ring and housing sealing surface. Avoid
dry spots or uneven build-up of lubricant.
2.
Close and latch the housing back. Press the latch
towards the housing until the lock buttons click into place.
3.
Check the latch. The buttons will not be depressed when
the latch is properly locked. Pulling on the latch without
pressing the buttons should not allow the latch to open.
Maintenance
Post-Dive
1.
Rinse the housing in fresh water. Rotate the housing
controls and press each button while submerged in fresh
water to flush out any salt or debris to ensure smooth
operation on future dives.
2.
NEVER leave your housing in the fresh water rinse tank.
Collisions with other peoples' gear can cause scratches or
damage to your equipment.
3.
Store the housing in a shaded place where it is protected
from impact or overheating. If no shade is available, we
recommend covering the housing with a towel or cloth.
Travel and Storage
1.
Remove the camera from the housing for travel or
storage.
2.
Check and lubricate the main housing o-ring.
3.
Close the empty housing and submerge in lukewarm
fresh water. While submerged, rotate each control and
depress each button to flush out any salt or debris.
4.
Remove the housing from water and rinse with running
water.
5.
Do not rinse the inside of the housing or submerge the
open housing in water. If the inside of the housing needs
to be cleaned, wipe with a clean, slightly damp cloth.
6.
Dry the housing with a clean, lint-free cloth.
7.
Store in a cool, dry place.
8.
Like regulators and other pressure-sensitive equipment,
we recommend careful cleaning along with annual
replacement of the factory seals.
Limited Warranty
This Ikelite product is warranted against any manufacturing
defects for a period of two (2) years from the original date
of purchase. To obtain warranty service, the product must
be returned to Ikelite postage paid. Ikelite will, at its sole
discretion, repair or replace such products, and will return
to customer postage paid. All other claims of any nature are
not covered. Except as mentioned above, no other warranty
expressed or implied applies to this Ikelite product.
Contact Us
Ikelite Underwater Systems
50 W 33rd St
Indianapolis, IN 46208 USA
(317) 923-4523
ikelite@ikelite.com
Advertisement
