WT Knowles & Sons KLH3P Fitting Instructions

Established 1906
nstructions
These instructions are for the fitting push-on tops into
existing pots.
The sketch shows the push-on top fitted to an existing pot
as a typical example. If a new pot is being installed with
push-on top, refer to the separate fitting instructions for the
particular pot.
Inspect the existing chimney pot and the new push-on top
and confirm they are undamaged.
Ensure the push-on top is suitable for use with the existing
chimney pot, flue system and the type of fire installed.
Using a sand/cement ratio of 3:1, apply a bead of mortar
around the top face rim of the chimney pot and fit the
push-on top in place. Align the push-on top with the
chimney pot and/or the chimney stack and ensure it is
vertical. Any exposed mortar at the joint should be
smoothed and angled downwards to allow rain to run away.
Fitting Instructions
Fitting Instructions
Hooded Leeds 3 Bowl Push-On Top
W T Knowles & Sons Limited
Ash Grove Pipe Works
Elland
West Yorkshire
HX5 9JA
www.wtknowles.co.uk
Hooded Leeds 3 Bowl
Push-On Top KLH3P
Existing Chimney Pot
(Example is Double
Beaded K10353)
Mortar bed
Exposed mortar
smoothed
©
Code No: KLH3P
October 2016: Issue 1
Push-on
top
Existing
pot
WT Knowles & Sons Limited 2016