Freezer Compartment; Troubleshooting - Atag KS37102A Instructions For Use Manual

FREEZER COMPARTMENT

Freezing fresh food
1. It is advisable to set the temperature colder or turn on the Fast Freeze/
Fast Cool* at least four hours before removing the food from the
freezer compartment, to prolong the preservation of the food during
the defrosting phase.
2. To defrost, unplug the appliance and remove the drawers. Leave
the door open to allow the frost to melt. To prevent the water from
escaping during the defrost, it is advised that you place an absorbent
cloth on the bottom of the freezer compartment and wring it out
regularly.
GENERAL INFORMATION
The drawers, baskets and shelves should be kept in their current position
unless otherwise specified in this quick guide. The light system inside the
refrigerator compartment uses LED lights, allowing for better lighting than
with traditional light bulbs, as well as for very low energy consumption.

TROUBLESHOOTING

What to do if...
The control panel is
switched off, the appliance
does not work.
The inside light does not
work.
The inside light flashes.
The temperature inside the
compartments is not low
enough.
There is water on the
bottom of the refrigerator
compartment.
Excessive amount of frost in
the freezer compartment
The front edge of the
appliance, at the door striker
seal, is hot.
* Available only on certain models
Possible reasons
There may be an appliance power
supply problem.
The appliance could be in On/stand by
mode.
The light may need to be replace.
Malfunction of a technical component.
Door alarm active.
It is activated when the refrigerator
compartment door remains open for a
prolonged period of time.
There could be various causes (see
"Solutions").
The defrost water drain is blocked.
The door of the freezer compartment
does not close properly.
This is not a defect. It prevents
condensation from forming.
3.
Clean the inside of the freezer compartment and dry it carefully.
4.
Turn the appliance back on and put the food back inside.
Ice cubes*
Fill 2/3 of the ice tray with water and put it back in the freezer
compartment. Do not, under any circumstances, use sharp or pointed
objects to remove the ice.
The quantity of fresh food that can be frozen in a specific time period is
indicated on the rating plate.
Load limits are determined by baskets, flaps, drawers, shelves etc. Make
sure that these components can still close easily after loading.
Doors and lids of the refrigeration appliance should be removed before
disposal in the landfill, to avoid children or animals getting trapped inside.
Solutions
Check that:
• there is not a power outage;
• the plug is properly inserted in the power socket and the mains
double-pole switch (if present) is in the correct position (i.e. allows
the appliance to be powered);
• the household electrical system protection devices are efficient;
• the power cable is not damaged.
Turn the appliance on by briefly pressing the "Temp." button (see On/
Stand-by function).
Disconnect the appliance from the power supply and contact the
Technical Assistance Service if you need a replacement.
To stop the alarm, close the refrigerator door.
On reopening the door, check the light works.
Check that:
• the doors close properly;
• the appliance is not installed near a heat source;
• the set temperature is adequate;
• the circulation of air through the vents at the bottom of the
appliance is not obstructed (see installation section).
Clean the defrosting water drain (see section "Cleaning and
Maintenance").
• Check that there is nothing preventing the door from closing
properly.
• Defrost the freezer compartment.
• Make sure the appliance has been correctly installed.
No solution is necessary.