Electrolux EW8F384BI User Manual page 36

36 www.electrolux.com
desired delay time. On the display
the indicator shows
2. Touch the Start / Pause
The appliance door locks and starts
the countdown of the delay start. The
display shows the indicator
When the countdown is completed, the
programme starts automatically.
Cancelling the delay start after
the countdown has started
To cancel the delay start:
1. Touch the Start / Pause
pause the appliance. The related
indicator flashes.
2. Touch the Delay Start button
repeatedly until the display shows
and the indicator
3. Touch the Start / Pause
again to start the programme
immediately.
Changing the delay start after
the countdown has started
To change the delay start:
1. Touch the Start / Pause
pause the appliance. The related
indicator flashes.
2. Touch the Delay Start button
repeatedly until the display shows the
desired delay time.
3. Touch the Start / Pause
again to start the new countdown.
12.9 The SensiCare System
load detection
The programme duration in
the display is referred to a
medium/high load.
After touching the Start / Pause
button, the maximum declared load
indicator goes off, the SensiCare System
starts the laundry load detection:
1. The appliance detects the load in the
first 30 seconds. In the programmes
where Time Manager is available,
button.
.
button to
goes off.
button
button to
button
during this phase the Time Manager
bars placed below the time
digits play a simple animation. The
drum rotates shortly.
2. The programme duration could be
adjusted accordingly and could
increase or decrease. After further 30
seconds, the water filling starts.
At the end of the load detection, in case
of drum overload, the indicator
flashing in the display:
In this case, for 30 seconds, it is possible
to pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Start / Pause
the programme again. The SensiCare
phase can be repeated up to three times
(see point 1).
Important! If the laundry amount will not
be reduced, the washing programme
starts anyway, despite the overload. In
this case, it will be not possible to
guarantee the best washing results.
About 20 minutes after the
programme start, the
programme duration could
be adjusted again depending
on the capacity of water
absorption of the fabrics.
The SensiCare detection is
carried out with complete
washing programmes only
and if the programme
duration has not been
reduced by means of the
Time Manager button.
The SensiCare System is
not available with all
programmes such as :Wool /
Silk, Rinse and programmes
with short cycles.
12.10 Interrupting a programme
and changing the options
When the programme is running, you
can change only some options:
1. Touch the Start / Pause
is
button to start
button.