Table of Contents
Advertisement
18
En
Preventing Equipment from Falling Over
_)
(cer installing the stand, be sure to take measures so that the equipment will not fall over.
Stabilizing on the floor
Stabilize the equipment as shown in the diagram using
screws that are available on the market.
To stabilize the equipment on the
floor use screws that have a
nominat diameter of 6 and that are
at least 20 mm (25/32 inch) long.
Min. 20 mm
|
25/32 inch} |
{
++ tat
—)
Max. 5 mm
(0.2 Inch)
« Angle of rotation: Without speakers
Unit: mm
(inch)
120
575 (22-21/32)*
(4-23/32)
500 (19-11/16)**
+
*
: 43 inch display model
** » 50 inch display model
¥
21 {13/16}
369 (14-17/32)
-"
Using a wall for stabilization
{43 inch display
model in the figure)
1 Attaching falling prevention bolts (hooks)
to the plasma display.
2 Using strong cords or chains to firmly
stabilize it to a wall, pillar, or other sturdy
element.
@ Perform this work in the same way on the teft and
right sides.
@ The lenath of the cords or chains used must be long
enough to allow the stand to rotate freely.
Use hooks, ropes, chains, and fittings
that are available on the market.
Recommended
hook: Nominal diameter 8
Length 12 to 15 mm
(15/32 inch}
12-15mm
(15/32 inch)
1 Hook
2 Cord or chain
\
9
Fitting
'
7
Detaching the Plasma Display from the Stand
To remove the plasma display from the stand, be sure
to always follow the procedure described below to
A
Caution
prevent accidents
1 First clear a space on a flat floor etc. where
you can lay the plasma display flat, then
cover the clear space with a sheet or other
material to protect it from scratches or
other damage.
2 Remove the speakers.
3 Referring to steps 2 and 3 in Attaching the
Plasma Display (Page 15.}), remove the
black screws (4 screws).
Advertisement
Table of Contents
