Advertisement
1.
10.0.0.x IP addresses. You can enter the Gateway and a DNS Server
1&2 address.
2.
d. Now select the "Serial" tab and check the "Modify" box. Now click
on the settings that appear below. A new window will pop up that will allow
user to change baud rate, parity, data bits, stop bits and flow control. The
3.
e. Now select the "Operating Mode" tab and check the "Modify" box.
Make a note of the port, usually 4001. In this case it was changed to 3001.
Once all these steps are completed and updated the user can close the
Network Enabler Administrator application.
Advertisement
