Battery Use; Environmental Protection And Recycling - Showmaster Easy Clip Manual

Charging
• Switch off the clipper and insert the charger into the clipper before plugging it into the main electrical socket. The red
indicator light signals that charging has started.
• The charging indicator lights up during charging. When it is almost full, the indicator light will fl ash continuously, and
the fl ashing stops to indicate that the battery is fully charged.
• Please charge in an environment of 5°C to 35°C.
• Charger input voltage is 100-240V~50/60Hz
• Charging time 3-4 hours.
• When fully charged, it can operate for more than 3 hours.
Warning!
Do not use non-rechargeable batteries on this product!

Battery use

• This product uses a rechargeable battery, the specifi cation is 18650 3.7V.
• Battery life depends on the frequency and duration of the battery. If the battery is not used for a long time, it is
recommended to charge the clipper at least once every 3 months to ensure battery life.
• If you fi nd that the battery is leaking, please wipe the product with a cloth, put the leaking battery in a plastic bag
and dispose of it at a designated recycling centre. Do not simply throw it away to avoid environmental pollution. If the
battery fl uid gets on your skin, please rinse it off with water. If you feel unwell, please seek medical advice.
Replacing the blade
1. The appliance must be switched off and not connected to the mains when the blade is replaced.
2. Loosen the screws on the blade; remove the lower and upper blade (Fig. 5) - you will need a Torx screwdriver T20
(not supplied with the product) for this purpose.
3. The blade can now be removed for cleaning or replacing.
4. To re-assemble, place the top blade on the plastic groove. (Fig. 6)
5. Position bottom blade and screw in the two screws.
6. Tighten screws (Fig. 5) - no blade alignment is required, once the Torx screws are tightened, the blade will be
automatically align in the correct position.
7. To attach the attachment comb, place the teeth of the attachment comb on top of the blade and carefully clip on.
(Fig. 3)
Warning!
Do not use the appliance if the teeth are damaged, missing from the blade or misaligned as damage may occur.

Environmental protection and recycling

The built-in battery may contain substances that pollute the environment. Remove the battery if you wish to dispose of
the unit. Dispose of the battery at a certifi ed recycling centre or company.
1. Switch on the clipper until it stops working and the battery is empty.
2. Disassemble the clipper before removing the battery, you must switch it off and disconnect the power.
5