Playing A Record - Onkyo CP-1057F Instruction Manual

racking)
2 motdtestbemscalelnglonly]
%
. 4
Now, slowly rotate the counterweight in the direction of
the arrow (the scale ring will also rotate) until the 1.7 gram
indication of the ring is allgned with the index line on the
tonearm.
After setting the appropriate amount of tracking force,
set the anti-skating knob to the same value. If this
is forgotten, the stylus may skid over the surface of the
record during record play.
Connections
Connect the output cord from the CP-1057F to the
PHONO terminals of your audio amplifier as shown
below. Connect the power cord to the socket on the
rear panel of the amplifier or the wall socket.
If the unit you have purchased is equipped with a cartridge,
the cartridge is an MC type. Therefore, the amplifier
cartridge selector should be set to the MC position before
using this unit for the first time.
Power cord
GND
PHONO
Do not reverse left and right output cords.
Playing a Record
Always wipe records with a good cloth to remove dust
and other particles before placing the stylus in the
starting grooves.
Also confirm that no dust is clinging
to the stylus. A dirty record and stylus can cause
unpleasant static during record play.
Fully Automatic Operation
1. Place a record on the turntable mat {1} and set the
Speed Selector [22] to the correct speed for the record
about to be played. The speed switches between 33 and
45 each time the Speed Selector [22] is pressed and
the corresponding indicator lights.
2. Set the Record Size Selector 21] to the correct
setting for the record about to be played.
The record size setting switches between 30 cm
and 17 cm each time the Record Size Selector
is pressed and the corresponding indicator lights.
3. Press the Play/Reject Button [16] ; the turntable
platter 3] will begin to rotate, and the tonearm 13}
will automatically move over to the record, lower
into the starting grooves and begin record play.
4. When the end of the record is reached, the tonearm
13] will automatically return to the arm rest 12 and
the turntable platter {3} will stop rotating.
5. To interrupt record play before the end is reached,
depress the Play/Reject Button [16] . The tonearm
13, will immediately return to the arm rest (12) and
the turntable platter!3\ will stop rotating.
6. Do not touch or forcibly move the tonearm during
this time as it will damage the automatic mechanism.
Manual Operation
Repeat Function
To operate the repeat function, simply depress the
Repeat Button 19]. The REPEAT
LED
indicator will
light up and the record will be played
again and again.
The repeat function is cancelled by depressing the
Play/Reject Button [16] to stop record play immediately,
or by depressing the Repeat Button [19] once more, in
which case the record will be played to its end. In
either case, the REPEAT
LED
indicator will turn off.