Page 4
Assembly instructions This paper craft was designed for 1:96 and 1:100 scales usually used for spacecraft paper model displays. Accordingly it is not detailed enough for larger sizes, however one can experiment with scaling it up to 1:48 or even larger. For the good quality of the model I recommend to print it on cardboard, the one depicted on the cover page was printed on a 200gramms/m cardboard.
Page 5
Steps: 1) Cut out the whole bottom part with its flaps. The front side in indicated. Cut slightly into the surface where the flaps and the part connects with a box cutter (use the same method later when a 90° or more fold is needed), this helps for easier bending. Cut out the fenders and glue to the bottom using the flaps.