Sony LBT-G1000 Operating Instructions Manual page 8

}
a?
You can listen to FM or AM stations.
34
STEREO/MONO 2 Display
— —
reer
—)—1—\—|—_ oor Yi i)
1 Press the TUNER button.
2 Press the TUNING/PRESET button to enter
the tuning mode.
"PRESET" and the preset code disappear.
3 Press the BAND button repeatedly until the
desired band appears.
| @ s880. |
Each time you press the BAND button, the received
band changes as follows:
FM — — AM
Keep the DUAL MODE TUNING + or - button
pressed for over one second so that "AUTO"
appears.
The unit starts scanning frequencies and stops
when it tunes into a station. Repeat this step until
the desired station is tuned in.
©
FA FU Be
The "TUNED" indicator appears
When a station of a sufficient signal strength is tuned in.
The "STEREO" indicator appears
When an FM stereo program of a sufficient signal strength is
tuned in.
When you press the TUNER button
The CD player is automatically turned off so that radio
broadcast may not be disturbed by noise.
For receiving FM stations in stereo
If the MONO indicator is lit, press the STEREO/ MONO
button so that the indicator goes out.
When an FM stereo program is noisy or hard to
receive
Press the STEREO/MONO button so that "MONO" appears.
This eliminates the stereo effect, but the noise will be greatly
reduced.
To return to the stereo mode, press the STEREO/MONO
button again. The MONO indicator goes off.
If you cannot tune in a desired station
A station with a weak signal may be skipped. In this case,
tune in the station manually.
¢ Press the DUAL MODE TUNING + or - button again to
stop scanning. Lo
¢ Press the DUAL MODE TUNING + or ~ button
repeatedly and tune in the exact frequency.
Note
The controls of the tuner become inactive when you press
any of the function buttons other than the TUNER button.
Changing the AM Tuning Interval
The unit tunes in AM stations at 10-kHz intervals. To use the
unit where the tuning interval is 9-kHz, change the setting as
follows:
Turn on the power.
Tune in any AM station.
Turn off the power.
While pressing the DUAL MODE TUNING + button,
turn on the power.
AWN wd
To reset the interval, repeat the same procedure.
Important
@ Stored stations will be erased from the memory when you
change the interval.
@ Stored stations will be erased from the memory when the
AC power cord is disconnected for a long time.