Specifications - Waring WSC300 Series Manual

PARTS
10
6
3b
1. ON/OFF Rocker Switch
2. Ready Indicator Light
3. Control Panel
a. Time and
Temperature Settings
b. + and – Buttons
c. Start/Stop Timer Button
5
4
7
4
1
2
3b
3a 3c
4. Housing
5. Handle
6. Base
7. Nonstick Cooking Surface
8. Power Cord (not shown)
9. Rubber Feet (not shown)
10. Spatula
6

SPECIFICATIONS

Model Electrical
WSC300 120V, 60Hz, 1800W
Out of Box Dimensions:
Depth – 21.875 inches (55.5 cm)
Width – 15.5 inches (38.7 cm)
Height Closed – 9.375 inches (23.8 cm)
Height Open – 24.75 inches (62.9 cm)
Cooking surface diameter – 13.5 inches (34.5 cm)
OPERATING INSTRUCTIONS
1. Plug the cord into an outlet, and flip the rocker switch to ON;
switch will illuminate to indicate power.
2. Default temperature is 350°F (177°C). To change the
temperature, press Settings button to toggle from time to
temperature. Hold down the Settings button for 3 seconds until
flashing. Use the + or – buttons to change the temperature.
Setting will be saved after 5 seconds.
3. Timer defaults to 1 minute. To change the time, hold down the
Settings button for 3 seconds. Use the + or – buttons to change
the time. Setting will be saved after 5 seconds.
4. When the unit is preheated to the set temperature, the unit will
beep and the ready light will illuminate. Preheating time will take
approximately 6 minutes depending on set temperature.
5. Pour batter onto middle of cooking surface and close the lid.
6. If using the timer, press the Start/Stop Timer button.
7. Timer will beep 5 times when cooking cycle is complete.
8. Use the provided spatula to fold crêpes. Do not use
sharp cooking utensils, as they could scratch the nonstick
cooking surface.
9. Repeat this process for additional crepes.
Adjusting Settings
TEMPERATURE
To change the temperature, press Settings button and then hold
down the Settings button for 3 seconds, until flashing.
Use the + or – button to change the temperature.
TIMER
To change the timer, hold down the Settings button for 3 seconds.
Use the + or – button to change the time.
Plug Approval
5-15P TUVus, NSF
7