Advertisement
4, Turn the entire balance weight clockwise (indicated by the
arrow A") of countrerclockwise (indicated by the arrow "B")
until the tonearm is approximately balanced horizontally.
(See Fig. 10).
Balance weight
Gueing lever
Tubular arm
re
a
~
=
'on the tonearm rear shatt, (The adjustment of the horizontal
Note:
1) During the adjustment of the horizontal balance, be sure
that the stylus tip of the cartridge does not contact the
turntable mat or turntable base.
Ensure that the anti-skating knob is at "0" position. (See
Fig. 11)
'There are cases where the tonearm may sway or flow
Slightly at the position of "0" due to the highly sensitive
rotational part of the tonearm, but this side force is trivial
'and presents no inconvenience.
Peoressure ring "0
3) Ensure that ine cueing lever is in the lowered position as
shown in Fig. 10.
4) Make certain that the speed selector is in the " s position.
the balance adjustment is easily made as the turntable
platter remains stationary,
clockwise in the direction of the arrow and align the correct
Note
1) As the stylus pressure ring rotates together with the ba-
lance weight. proper stylus pressure can be selected by
directly reading the graduated ring,
2) Set the stylus pressure to the maximum value of your
Cartridge in cases where the record has an extremely high
recording level, or where the unit is operated in @ room at
low temperature or in places in which the unit is liable
to be subjected to vibrations
@anti-s skating force control.
Set the anti-skating force control to the same value as that set
tor stylus pressure. (See Fig. 13)
Place the dust cover into position from directly above
at both sides. For detaching the dust cover, be c
raise it as illustrated betore removal
holding it
tain first to
Dust ccver
Note
Opening or closing of the dust cover during playing should be
made as gently as possible, since this may not only cause
harmful vibrations, but also result in skipping of the stylus.
@Placement.
3. Do net place the unit where it is exoosed to direct sun, dust,
moisture or heat
4. Keep it in a well-ventilated place.
@connect the AC power plug.
Connect the AC power plug to the AC socket
Jn cases where the AC power plug is connected to the outlet
(AC outlet) of the amplifier. receiver and the like. make sure
that the wattage indicated on the outlet corresponds to the
turntable's requirements botore connecting the power plug
'®Cconnect the output terminal
'Output termi
or Receiver
Lwnite)
Channel
R (Red)
Channel
E (Spade !ug) ——- EX)
Note:
Be sure to connect the ground terminal to the amplifier of
receiver. It this connection is not made or is loose, a power
source HUM" will result
Advertisement
