Introduction Thank you for purchasing a JBL DA series distribution amplifier. The DA850 and DA1650 amplifiers are designed, engineered, and manufactured to the industry’s highest quality standards and offer system integrators with the core features and fundamental connectivity for home audio distribution.
See "Specifications" on page 13 and 14 for supported load specifications. JBL recommends using two-conductor or four-conductor, heavy gauge speaker wire up to 12 AWG. For low-impedance loads, refer to the table below and select the appropriate size of wire based on the distance from amplifier to speaker.
Page 9
Speaker outputs provide connection for: Up to four pair of stereo speakers (eight speakers total) to the DA850 Up to eight pair of stereo speakers (sixteen speakers total) to the DA1650 Connection to speakers is provided via phoenix-type connectors that accept bare wire terminations. The connectors are grouped in pairs with one connector each for pair.
7. Do not operate the amplifier with less than the rated load impedance. Due to the amplifier’s output protection, such a configuration may result in premature clipping and speaker damage. REMEMBER: JBL/ HARMAN is not liable for damage that results from overdriving other system components.
If the unit is exposed to a dusty environment, a low-pressure blower may be used to remove dust from its exterior. JBL DA850 DA1650 Owners Manual | rev1.2 Draft20231009 Pg 15 of 16...
Page 16
United registered States and other countries. Features, Specifications, and Appearance subject to change without notice. JBL DA850 DA1650 Quick Start Guide | Rev 1.2 Draft20231009 | Features, Specifications, and Appearance subject to change without notice. Pg 16 of 16...