Advertisement
9. PANEL FACILITIES
FRONT
a
CO-ROMWARITER
DW-S
114X
@) POWER switch
This switch turns the power supply ON/OFF
2) POWER indicator
Lights up when the power is ON.
@) Disc tray
Auto-loading is done with the OPEN/CLOSE button.
Place the disc onto the tray with the label facing up.
@) DISC indicator
Lights up when loading the disc Blinks during reading of TOC
data.
© READ indicator
Lights up when during reading of CD-ROM data Blinks during
searching of CD-ROM data.
@ WRITE indicator
Lights up during writing of CD-ROM data.
@ ERROR indicator
Lights up when some trouble occurs during use of the unit.
OPEN/CLOSE button
Press this button when moving the disc tray in and out.
REAR
@) SCSI connectors
Two SCS! amphenol 50P connectors are implemented for
daisy chain configuration connectors.
(Either one of the two connectors can be used.}
() FUNCTION switches
Used to set the operation mode of the unit. Turn the power off
to the unit before changing the operation mode. See page 6 for
details.
) GND terminal
@2 AC IN
Connect to a wall outlet. The unit is designed to operate at AC
100 - 240V 50/60Hz. (There is no power supply voltage switch
because switchover takes place automatically inside the unit.)
POWER-CORD CAUTION
Handle the power cord by the plug. Do not pull out the plug by
tugging the cord and never touch the power cord when your
hands are wet as this could cause a short circuit or electric
shock
Do not place the unit, a piece of furniture, etc , on the
power cord, or pinch the cord. Never make a knot in the cord
or tie it with other cords. The power cords should be routed
such that they are not likely to be stepped on. A damaged
power cord can cause a fire or give you an electrical shock
Check the power cord once in a while. When
you find it
damaged, ask your nearest PIONEER authorized service center
or your dealer for a replacement.
Advertisement
