Yamaha GRIZZLY 550 2010 Owner's Manual page 105

TIP
If the engine was started before checking the oil
level, be sure to warm up the engine sufficiently,
and then wait at least 10 minutes until the oil settles
for an accurate reading.
3. Remove panel F. (See page 8-10.)
4. Remove the engine oil dipstick, and then wipe
it off with a clean rag.
1. Engine oil dipstick
5. Insert the dipstick completely into the oil filler
hole, and then remove it again to check the oil
level.
TIP
The engine oil should be between the minimum
and maximum level marks.
1. Maximum level mark
2. Minimum level mark
6. If the engine oil is at or below the minimum
level mark, add sufficient oil of the recom-
mended type to raise it to the correct level.
NOTICE: Be sure the engine oil is at the
correct level, otherwise engine damage
may result.
[ECB00851]
7. Insert the dipstick completely into the oil filler
hole.
8. Install the panel.
8-25
8