Panasonic WV-CL700 Operating Instructions Manual page 21

(2)
(4)
Cut off the inner cable covers of the iris control
cable as shown in the diagram.
Approximately 6 mm
Put the heat shrinkable tubes or equivalent tubes on
the inner cables of the iris control cable.
Solder the inner cables of the iris contro! cable at
the pin-plug block according to the following pin
assignment and cover the heat shrinkable tubes or
equivalent tubes at soldered area and the heat on
the tubes to shrink.
Pin 1: Power source; +6V DC, 50mA Max.
Pin 2: Not used
Pin 3: Video signal; 0.7Vp-p/40 kohms
Pin 4: Shield, ground
(When the Lens Selection Switch (7) is set to the
VIDEO position)
(5) Both the connector cover and connector should be
positioned to interlock.
Connector
cover
Automatic
Cc iris lens
Heat
shrinkable — Iris control
tubes cable
Connector
Note:
Cut off the rib on the connector, when the iris
control cable is thick and the connector cover
and connector can not locked.
-18-