Advertisement
A S S E M B LY I N S T R U CT I O N S
8.
You're almost finished. Using the screwdriver, press in the four recesses on the underside of
the keyboard.
9.
Position the keyboard so that the wooden pegs on top of the legs fit into the holes in its
underside.
10.
Secure the keyboard to the metal brackets on the wooden frame using four hand screws
(M6X20). Don't overtighten them, otherwise it will be difficult to undo them again later (see
3.1 to 3.4 in Figure A).
11.
Using the screwdriver, press in the two recesses above the control element on the top of the
keyboard as you did in Point 8, then position the music stand on the keyboard before fixing
it in place using two hand screws (M6X20).
12.
Take the DIN connector from the cable that you pulled out of the cavity in the pedal bar in
Point 3 and connect it to the DIN socket located to the right on the bottom of the keyboard
(see figure below).
NOTE:
important! DO NOT connect the cable from the pedal bar to the MIDI
socket on the back of the piano.
6
13.
Connect the power supply unit to the back of the piano and insert its plug into a 220 V
socket (see figure below).
DC 9–15 V
NOTE:
only disconnect the power cable if you want to transport the keyboard.
And in this case, unplug the power cable from the socket before removing the
plug at the back of the piano.
14.
To switch on the piano, press the „ON/OFF" switch and turn up the volume using the large
round knob just above the switch.
7
Advertisement
