Advertisement
A S S E M B LY I N S T R U CT I O N S
Assembly video
The easiest way to assemble your OLYA is to visit us at
www.feurich.com/en/olya, and watch our assembly video.
NOTE:
assembling your OLYA is quick and easy. Because some of the parts
are quite big, we recommend getting another person to help.
Left leg
3.1
3.2
1.1
1.2
2.1
2.2
Back panel
Pedal bar
Wood screws M5X50 (4x)
Metal screws M6X50 (4x)
for steps 1.1, 1.2, 1.3, 1.4
for steps 2.1, 2.2, 2.3, 2.4
4
Figure A
Keyboard
Right leg
3.3
3.4
1.3
1.4
2.3
2.4
Hand screws M6X20 (6x)
for steps 3.1, 3.2, 3.3, 3.4
1.
Remove all the parts from the packaging and lay them out. In the cavity in the pedal bar,
you will find a little bag containing all the connecting elements, a screwdriver, the power
cable and the operating instructions.
2.
Use two metal screws (M6X50) to connect a leg to the pedal bar. The open side of the leg
should face forwards and the black brackets upwards, so that you can fix the keyboard to
them later. Begin by pushing two metal screws through the two recesses that are at the
bottom of the outside of the leg, then tighten those screws to secure the leg to the pedal
bar (see 2.3 and 2.4 in Figure A).
3.
Undo the power cable which is in the cavity in the pedal bar and thread it out through the
opening at the back right. (Point 12 explains how to connect the cable to the bottom of the
keyboard.)
4.
Use two wood screws (M5X50) to attach
the back panel to the same leg to which
you just attached the pedal bar. The
procedure for this is the same as for Point
2: start by pushing the wood screws
through the two recesses in the middle of
the outside of the leg, then tighten those
screws to secure the back panel (see 1.3
and 1.4 in Figure A).
5.
Now lay the outside of the leg flat on the
floor so that the pedal bar and back panel
point upwards.
6.
Repeat the steps in Points 2 and 4 to connect the second leg to the pedal bar and back
panel (see 1.1, 1.2, 2.1, 2.2 in Figure A).
7.
Now place the assembled wooden frame back on the floor with the pedal bar at the bottom
and use the eight covers provided to cover the openings on the outside of the legs where you
inserted the screws in the previous steps.
5
Advertisement
