ENGLISH
RECORDING (DECK B only)-
•
Switch on your amplifier or receiver and the source component,
•
Set the Tape Monitor switch on your amplifier or receiver to the SOURCE position.
(T) Press the POWER switch to the ON (
) position.
© Load the cassette tape.
(Check that the erasure prevention tabs of the cassette housing have
not been broken off.)
© Move the DOLBY NR switch and select the Dolby NR type that suits the
recording.
DOLBY NR
B
OFF
C
—nr~
CED
Caution:
•
Be careful not to erase important recordings by mistake. Inadvertent
start of recording wilt happen in the following cases:
1. If the PLAY button is pressed while the • indicator lights, recording
starts.
2. If the PLAY and REC/REC MUTE {•) button are pressed at the same
time, recording starts.
The best way to avoid accidental erasure is to break off the two erasure
prevention tabs on the cassette housing.
(
4
) Press the Direction (4 ►) button to select the direction of tape
transport.
® Select the type of tape transport with the REVERSE MODE switch.
Mode
Switch position
To record on only one side
To continuously record
on both sides
CD
or RELAY
© Press the REC/REC MUTE (•) button to set the recording pause mode.
The ell indicator will light up.
® Adjust the recording level with the INPUT LEVEL control while watching
the Peak Level Meter
© Press the PLAY button to start the recording.
The PLAY (0 or t>) and the • indicator will light during recording.
© To pause the recording, press the REC PAUSE (II) button. Press the
PLAY button to resume recording.
© To stop recording, press the stop ( ■ ) button,
10