Advertisement
INSTALLATION INSTRUCTIONS
If you intend the drain hose
from the machine to empty
into a sink, make sure that the
sink is empty and that the plug
hole is not blocked.
If
the
machine
is
permanently plumbed in, hook
the end of the drain hose into
a standpipe installed for the
purpose.
The standpipe must have an
internal diameter of at least
30 mm (1 1/2 in), in order that
there is an air gap between the
drain
hose
and
standpipe.
Make sure, that it is designed
in such a way, that the end of
the drain
hose
cannot
be
covered with water.
Important:
Before
con-
necting up the machine
to
new pipework or to pipework
that has not been used for
some
time,
run
off
a
reasonable amount of water
to flush out any debris that
may
have
collected
in the
pipes.
Whether discharging into a
sink or a standpipe check that
the end of the drain hose is
neither too high nor too low.
The top of the curve in the
hose's end should be no more
than 90 em (35.4") and no less
than 60 cm (23.6") above floor
level.
ELECTRICAL CONNECTION
WARNING:
THIS APPLIANCE
MUST BE EARTHED
The manufacturer declines
any
liability
should
this
safety
measure
not
be
observed.
If the plug that is fitted to
your appliance is not suitable
for your socket outlet, it must
be cut off and the appropri-
ate plug fitted.
The cut off plug should be
disposed of to prevent the
hazard of electric shocks in
case it should be plugged into
a 13 Amp socket in another
part of your home.
Important
The wires in this mains lead
are
coloured
in accordance
with the following code:
GREEN AND
YELLOW
- EARTH
BLUE
- NEUTRAL
BROWN
- LIVE
If you fit your own plug, the
colours of the wires in the
mains lead of your appliance
may not correspond with the
markings
identifying
the
terminals in your plug, this is
what you have to do:
Connect
the
green
and
yellow (earth) wire to the
terminal in the plug which is
marked with the letter «E» or
the earth +
symbol
or
coloured green, or green and
yellow.
Connect the blue (neutral)
wire to the terminal in the plug
which is marked with the letter
«N» or coloured black.
Connect
the
brown
(live)
wire to the terminal which is
marked with the letter «L» or
coloured red.
The plug moulded on to the
cord incorporates a fuse. For
replacement, use a 13 Amp BS
1362 fuse.
Only ASTA approved fuses
should be used.
The fuse cover/carrier must
be replaced in the event of
changing fuse.
The right fuse cover/carrier
colour is the one shown by the
coloured insert at the base of
the plug.
The plug must not be used if
the fuse cover/carrier is lost.
A replacement
cover/car-
rier must be obtained from
Zanussi Service Agents whose
addresses are listed on the
attached
«Zanussi
Service
Force Directory» or you could
find your local agent by looking
in your telephone directory
under "Z".
This
appliance
complies
with
E.E.C.
directive
no. 87/308 of 2.6.87 relative
to
radio
interference
suppression.
Advertisement
