Table of Contents
Advertisement
top baffle plate by sliding the baffle back and allowing the front of the baffle to drop
down. Removing the top baffle will expose the top heat exchanger tubes. The right
and left side baffles attach to the side heat exchanger tubes with an angle iron
bracket.
While picking straight up on the baffle plate, pull the plate forward and
remove from the unit.
All the heat exchanger tubes should be exposed.
Use a
vacuum and remove all the ash build up on the exchanger tubes and in the firebox.
At the bottom left rear in the firebox, you will notice a rectangle hole, be sure to clean
the hole out. After you have cleaned the unit, replace the two side baffles and the
top baffle.
Control Board
To replace the control board, unplug the power cord from the power supply,
disconnect all leads from the back side of the control panel, remove the two screws
holding the control panel in place. The control panel and bracket will come out. Do
not try to remove the buttons or knobs, the replacement board will include new
brackets and knobs.
To replace the new board, connect all leads using the wiring
diagram and remount the board.
Gaskets
Each unit comes with a gasket kit around the door. This gasket should be replaced
every two years. To replace, pull old gasket from channel frame by using a flathead
screw driver to scrape the gasket and cement fromthe channel frame. Place the new
gasket in the frame and allow the adhesive to set up 24 hours before building a fire.
If you have glass in your door, it may be necessary to replace the window gasket.
However, this gasket will only have to be replaced if you remove your glass.
To
replace, remove glass from door. Pull old gasket off and scrape off oid adhesive. The
AC-GGK Glass Gasket Kit has adhesive side on the edge of the glass. Start at one
corner and go all the way around the outer perimeter of the door gasket kit for your
25-PFS & 25-PFSP is AC-DGKC and the replacement window gasket is AC-GGK.
Both can be purchased through your local Englander Dealer or ordered direct from
the factory.
Finish (Part #AC-MCSP)
Your Englander product has been painted with 1200F Metallic Charcoal Paint which
will retain its original look for several years. However, if your unit should get wet, rust
spots might appear.
Use steel wool to remove the rust and repaint the area with
Englander AC-MCSP.
When you repaint, use only Englander paint because other
paints may not adhere to the Englander paint. You can purchase Englander paint
from your local Englander Dealer or direct from the factory.
External Thermostat
When starting a pellet unit using an external thermostat, it is a good idea to set the
external thermostat to its highest setting which will enable the unit to be operated in
a higher mode setting. This will get fuel to the burn pot faster and get the unit hotter
faster. Aflertheunitis heated up, reset the external thermostat to the desired setting.
LIMITED 5-YEAR WARRANTY
England Stove Works extends the following warranties for our products to the
original owner:
Advertisement
Table of Contents
