Chapter 3 Connections.g; Setup - Peavey Spectrum Bass II Operation Manual

Chapter 3
Connections
Chapter 3 Connections
SETUP
When you power up the Bass II for the first time, you should see the program LED display come to life. In the display
will be three numbers, i.e., 001. This represents the current preset (or patch) number. Once you have connected
the Bass n to your MIDI keyboard (either using the diagrams in this chapter or the Quick Start guide) you should
set the MIDI receive channel. Set the MIDI receive channel by pressing and holding the button labeled Channel,
then use the ▼ or ▲ button to move to the desired channel. You probably want to set the MIDI mode as well. To
do this, press and release the Mode Select button until the LED above the desired mode is lit. If you are unsure which
mode you want, try using OMNI. For a more complete description of the MIDI modes see Chapter 4.
The rear panel consists of your stereo/mono outputs and MIDI In, Out and Thru jacks, and power input jacks.
To see if MIDI is being received, send MIDI data (notes, mod. wheel, etc); there should be a little dot in the bottom
right comer of the LED display showing the reception of any MIDI data.
8
SpectrumBass II