JVC AV-14F703 User Manual page 7

REMOTE CONTROL BASICS
• Before you can operate the remote control, you must
first install the batteries (included). See "Changing the
Batteries" on this page above for instructions. (For an
illustration, please see page 6.)
• Press the POWER button to turn the television on or
off.
• Make sure the TV/CATV switch is set to TV. Move the
switch to
CATV only if you need to operate a cable box.
Slide the VCR/DVD selector switch to VCR to control
a VCR, slide to DVD to control a DVD player. Please
see pages 8 to 10 for instructions on programming
your remote control to operate a Cable box, VCR or
DVD player.
Press the CH + and CH - buttons to scan through the
channels. Tap the CH + or CH - button to move
Press VOL + or VOL - to raise or lower the volume.
An indicator bar will appear onscreen to show you the
television volume level.
The CH +/- and VOL +/- buttons are also used to
10-key pad.
• This remote includes illuminated buttons for key
features like CH +/- buttons, and VOL +/- buttons.
Press the LIGHT button to tur
CHANGING THE BATTERIES
towards the bottom to remove it.
Insert two AA batteries (supplied), carefully noting the
"+" and markings on the batteries and on the remote
When batteries are installed, slide the cover back into
place (until it clicks into position).
• If the remote control acts erratically, replace the
We recommend using alkaline batteries for longer
battery life.
When you change the batteries, try to complete the
task within three minutes. If you take longer than three
minutes, the remote control codes for your VCR, DVD,
and/or Cable Box may have to be reset (pages 8-10).
BATTERY PRECAUTIONS
batteries in this device:
2. Be sure to follow the correct polarity when installing
the batteries as indicated in the battery compartment.
Reversed batteries may cause damage to the device.
To avoid a potential short circuit, insert the " end
3. Do not mix different types of batteries together (e.g.
Alkaline and Carbon-zinc) or old batteries with fresh
4. If the device is not to be used for a long period of time,
remove the batteries to prevent damage or injury from
possible battery leakage.
recharged; they can overheat and rupture. (Follow
battery manufacturer's directions.)
6. When you change the batteries, try to complete the
may have to be reset (see page 8).
EFFECTIVE DISTANCE OF THE REMOTE
CONTROL TRANSMITTER
■ 4
operate.
• When direct sunlight, an incandescent lamp,
fluorescent lamp or any other strong light