Advertisement
B. 地排水管（S弯管）
请遵照如图所示安装排水管和龙头。请遵照供应商所提供
的说明设置进、排水管位置。
注意：热水（H）及冷水（C）入口必须连接至正确的进水
管。安装冷热供水管必须使用隔离阀。
• 请确保所有洗衣盆排水的连接处都装有防水密封
圈。
• 管道连接处需要留有检修空间，以备日后管道维护
之用。
五、完成浴室柜安装
1. 调整铰链螺丝使门板平整。
2. 根据制造商提供的说明书，将龙头安装上脸盆或者台
面。
3. 连接冷热供水管。
4. 安装落水，并上紧。
5. 打开冷、热水阀门，检查供水管接头处是否有渗漏。
B. Floor Drain Pipe (S-type Elbow Pipe)
Install the drain pipe and faucet according to the figure
below. Please refer to the instructions provided by the
supplier for how to define the position of the inlet and
outlet pipes.
龙头 Faucet
供水管 Water supplies
止水阀 Faucet stems
排水管 Drain pipe
排水口 Outlet
Note: The hot water (H) and cold water (C) inlets must be
connected to the correct water inlet pipe. Hot and cold
water supply pipe installation must use isolation valve.
• Make sure that all the drainage connections of the
washtub are equipped with waterproof seals.
• There should be maintenance space at the pipe
connection for future pipeline maintenance.
Finish Installation of Bathroom Cabinet
1. Adjust the hinge screws to make the door flat.
2. Install the faucet on the washbasin or countertop.
3. Connect the hot and cold water supply pipes.
4. Install the falling water and tighten it.
5. Open the cold and hot water valves and check for leaks
at the water supply pipe joints.
9
Advertisement
