Erreka ULTRA Quick Installation And Programming Manual

ULTRA
Quick installation and programming guide
This quick guide is a summary of the complete installation guide. The guide contains safety warnings and other
explanations that must be taken into account. The most recent versions of this guide and the installation manual
are available in the "Downloads" section on Erreka's website. http://www.erreka.com.
WARNING
The options and functions described in this guide apply for the firmware version indicated on the circuit. The
firmware, as part of a process of continuous improvement, is subject to new functionalities or upgrades being
included as a result of new versions which are not necessarily compatible with previous ones. For this reason,
some options or functions may differ or be unavailable if your firmware is older than shown in this guide.

Unlocking should be carried out with caution. The internal
spring may cause jolting if the barrier is not balanced or the
arm is not mounted.
D289A
ONLY UNLOCK THE BARRIER IF THE ARM IS INSTALLED.
Elements of the complete installation
Unlocking
Unlocking
(manual drive)
Turn the key (L) clockwise
until it is released.
L
Locking
(motorised drive)
T u r n t h e k e y ( L ) a n t i -
clockwise until locked.
L

The drawing shows a right
side barrier
ULS45ECD).
Electrical cables
A: Main power supply
2
3x1.5mm
B: Flashing light
2
2x0.5mm
C: Photocells (Tx / Rx)
2
2x0.5mm
D: Key switch
2
2x0.5mm
E289A
Locking in opening position

The bar (arm) can be moved and left locked
in opening or closing position.
• To do this, turn the bottom shaft (E) of the
geared motor so the arm is locked in
opening position.
English
(ULS6ECD,
(max. 30m)
2
/ 4x0.5mm (max. 30m)
(max. 25m)
E
D289E
7