Overheat Protection; Over-Flow Protection - FabianoSteel SVH 326 User Manual

EN
Detection of Pan and Small Articles
For induction hob, if display flashes "
Pls check:
• you have not placed a pan on the correct cooking zone or,
• the pan you're using is not suitable for induction cooking or,
• the pan is too small or not properly centered on the cooking zone.
Notes:
1. No heating takes place unless there is a suitable pan on the cooking zone.
2. The display will auto turn off after 2 minutes if no suitable pan is placed on it.
3. When an unsuitable size or non-magnetic pan (e.g. aluminum), or some other small item (e.g. knife, fork,
key) has been left on the hob, the corresponding cooking zone will automatically turn off in 1 minute.
Residual Heat Warning
Beware of hot surfaces
When the hob has been operating for some time, there will be some residual heat. The letter "
power setting indicator to warn you to keep away from it. It can also be used as an energy saving function: if
you want to heat further pans, use the hotplate that is still hot.
Over-heat Protection
A temperature sensor equipped can monitor the temperature inside the hob. When an excessive temperature
is monitored, the hob will auto stop operation.

Over-flow Protection

For your safety, the programmer will auto shut off the power if liquid boiling or wet cloth over touch control
panel. All control buttons became invalid except ON/OFF and Child Lock button, unless you wipe the touch
control area dry.
Failure Inspection for hob
If an abnormality comes up, the induction hob will enter the protective state automatically and display
corresponding protective codes:
For all other error codes, switch off and call your service provider and have consultation.
" alternately with heat setting.
for induction models
for all models
H
"appears in
for all models
for all models
for induction models