Table of Contents
Advertisement
EN
6. All labels and warning marks should be visible after the installation. Do not scrawl, damage,
or cover any label on the device.
7. Do not touch the running equipment to avoid being hurt as its temperature may exceed 60°C.
Do not install the equipment at a place within children's reach.
8. Unauthorized dismantling or modification may damage the equipment, the damage is not
covered under the warranty.
9. If there is any radio or wireless communication equipment below 30MHz near the inverter,
you have to:
• Install the inverter at least 30m far away from the wireless equipment.
• Add a low pass EMI filter or a multi winding ferrite core to the DC input cable or AC output
cable of the inverter.
10. Warning labels on the inverter are as follows.
HIGH VOLTAGE HAZARD.
Disconnect all incoming power
and turn off the product before
working on it.
Read through the guide before
working on this device.
High-temperature hazard. Do
not touch the product under
operation to avoid being burnt.
CE marking
Delayed discharge. Wait 5 minutes
after power off until the components
are completely discharged.
5min
Potential risks exist. Wear proper
PPE before any operations.
Grounding point. Indicates the
position for connecting the PE cable.
Do not dispose of the inverter
as household waste.Discard the
product in compliance with local
laws and regulations, or send it back
to the manufacturer.
2
Advertisement
Table of Contents
