UNPACK CARTON & INSTALL HANDLE (See
Fig. 2)
A
CAUTION:
Be careful of exposed
staples when handling or disposing of
cartoning material.
IMPORTANT:
WHEN UNPACKING AND ASSEMBLING
TILLER, BE CAREFUL NOT TO STRETCH OR KINK
CABLE(S).
9
Cut cable ties securing handles.
9
Slowly lift handle assembly up and align handle holes
with handle panel hole and slot.
•
Loosely assemble hardware as shown. Be sure the
shorter (3/4" long) hex bolt is assembled in lower hole
of handle.
Repeat for opposite side.
Tighten all
hardware securely.
*
Cut cable ties securing tiller to skid and remove tiller
from skid.
INSTALL DEPTH STAKE ASSEMBLY
(See Fig. 3)
•
Loosen nut "A".
8
Insert stake support between engine bracket halves
with stake spring down.
•
Bolt stake support to engine brackets with hex bolts,
lock washers and nuts. Tighten securely. Tighten nut
A .
8
Depth stake must move freely. If it does not, loosen
support bolt.
HANDLE HEIGHT
®
Handle height may be adjusted to better suit operator.
(See "HANDLE HEIGHT" in the Service and Adjust¬
ments section of this manual).
TILLING WIDTH
«
Tilling width may be adjusted to better handle your
tilling conditions (See "TINE ARRANGEMENT" in the
Service and Adjustments section of this manual).
TINE OPERATION
•
Check tine operation before first use. (See "TINE
OPERATION CHECK" in the Service and Adjustments
section of this manual).