Table of Contents
Advertisement
CUSTOMER RESPONSIBILITI
MUFFLER
Do not operate titter without muffler. Do not tamper with
exhaust system. Damaged mufflers or spark arresters
could create a fire hazard, inspect periodically and replace
if necessary, if your engine is equipped with a spark
arrester screen assembly, remove every 50 hours for
cleaning and inspection. Replace if damaged.
SPARK PLUG
Replace spark plugs at the beginning of each tilling season
or after every 50 hours of use, whichevercomesfirst. Spark
plug type and gap setting is shown in "PRODUCT SPECI¬
FICATIONS" on page 3 of this manual.
TRANSMISSION
Yourtransmission is sealed and will only require lubricatio
if serviced.
CLEANING
®
Clean engine, wheels, finish, etc. of all foreign matte
•
Keep finished surfaces and wheels free of all gasoline
oil, etc.
•
Protect painted surfaces with automotive type wax.
We do not recommend using a garden hose to clean yoi
unit unless the muffler, air filter and carburetor are covere
to keep water out. Water in engine can result in a shorten©'
engine life.
SERVICE AND ADJUSTMENTS
A
CAUTION: Disconnect spark plug wire from spark plug and place wire where it cannot come into
contact with plug.
TILLER
TO ADJUST HANDLE HEIGHT (See Fig. 15)
Factory assembly has provided lowest handle height. Se¬
lect handle height best suited for your tilling conditions.
Handle height will be different when tiller digs into soil.
•
If a higher handle height is desired, loosen the four nuts
securing handle panel to engine brackets.
•
Slide handle panel to desired location.
•
Tighten the four nuts securely.
TINE ARRANGEMENT
Your outer tines can be assembled in several different way:
to suit your tilling or cultivating needs.
CAUTION:
Tines are sharp.
Wear
jftJL
gloves or other protection when harv-
%l§pl§|
dling fines.
NORMAL TILLING - 24761 cm PATH (See Fig. 16)
•
Assemble holes "A" in tine hubs to holes "B" in tint
shaft.
FIG. 15
Advertisement
Table of Contents
