ice-watch ICE CLEAR SUNSET Quick Start Manual

Getting started
Remove the plastic
stopper (in the direction
of the arrow).
Instructions
The watch must be serviced regularly in order for it to work correctly. The length of time between
services will vary depending on the model, climate and the care you take of your watch. As a
general rule, we recommend the following steps so that you can keep your watch in tip-top
condition for as long as possible.
- Temperature: avoid temperatures below 0°C (30°F) or above 35°C (100°F).
- Avoid prolonged exposure to sun, steam, contact with alcohol, detergents, perfume or
cosmetic products to prevent distorsion, discoloration or any damaging reaction.
- Do not use any watch button while under water to prevent water from entering the
mechanism.
The information contained in this document belongs to ICE Universal Ltd and may not be
reproduced without its authorisation.
ENGLISH
Press
the winder.
Minute hand
Hour hand
Second hand
A) SETTING THE DATE
1. Gently pull the winder out to the 1st position.
2. Turn the winder anticlockwise to set the date. If the date is set between around 9pm and
1am, it is possible that it will not change the next day.
3. Return the winder to its normal position.
B) SETTING THE TIME
1. Gently pull the winder out to the 2nd position.
2. Turn the winder to set the hour and minute hands to the correct positions.
3. The second hand starts again when the winder is pushed back into its normal position.
C) SETTING THE DAY OF THE WEEK
1. Gently pull the winder out to the 1st position.
2. Turn the winder clockwise to set the day of the week. If the day is set between around 9pm
and 1am, it is possible that it will not change the next day.
3. Return the winder to its normal position.
Day of the week
(the position may
vary depending on the model)
Normal winder position
1st position
2nd position
Date
(the position may vary depending
on the model)