Table of Contents
Advertisement
Final Adjustments
With the GRAFIX and CAM-1000 operational, it is time to make the final adjustments. One of the simplest ways to check
for backup camera alignment is to find a parking lot with drive through front to back parking spaces.
•
Pull through the parking spaces so that the back bumper of the vehicle is just ahead of the cross stripe between
the two parking spaces
•
Turn off the vehicle, engage the park brake, turn on the key (not engine) and place transmission in reverse
•
Observe the video on the GRAFIX
•
Adjust the CAM-1000 up and down so that the parking lot's 'cross' strip is visible on the bottom of the GRAFIX
display. If needed - 'tweak' the CAM-1000 left and/or right so that the side stripes appear equal on the GRAFIX
display, and are symmetric with the assist lines (if present)
•
Tighten the CAM-1000 alignment screw with the provided hex wrench
Note: Be sure to remove the protective film from the camera lens
Troubleshooting guide
Problem
GRFX Display Panel does not
display camera video or have
a blue raster
When in reverse, blue raster
on GRAFIX, but no camera
video
Video image is not clear and/or
appears noisy
Video looks foggy/fuzzy
Specifications
Sensor
Resolution
TV Line
Min Illumination
Angle
Voltage
Max Current
Video System
Image
Parking Lines
Water Proof
Operating Temp
Storage
Possible cause
GRAFIX camera trigger not configured
Reverse detection sensor is not functioning or is
wired incorrectly
Vehicle is not in reverse
Camera is not powered on
Video not getting to the Instrument Cluster
Contaminants on camera lens
Faulty video connection
Noise getting on power or video wires
Bad or noisy GND connection
Protective film still on lens
CMOS
648 x 488
480
0.3 Lux
170
9-16V
100mA
NTSC
Mirror (Default)
ON (Default)
IP67, IP68
-30C - +70C
-40C - +105C
[6]
Solution
Go in to the GRAFIX SETUP menu and set the
proper trigger according to the wiring
Confirm wiring is correct and trigger is present
Make sure vehicle is in reverse
Check that camera is getting power when
vehicle is in reverse
Check that all the yellow RCA connections
are secure
Clean lens with a soft cloth
Check all connections and wiring
Try different power source to the camera or
rerouting the cables from camera to the
GRAFIX
Check GND connection of PWR In/Video
Output Cable. May need to relocate GND
Closer to the GRAFIX Instrument Cluster
Be sure to remove the protective film from the
lens
MAN #650821
Advertisement
Table of Contents
