Table of Contents
Advertisement
Basic Wiring Block Diagram
Before getting started with the installation of the CAM-1000 in the vehicle, the user must select a mounting location and
understand the wiring requirements. Questions to ask could include:
•
Where and how will the camera be mounted?
•
Where will the power for the camera be sourced?
•
What is the source for the trigger signal to the GRAFIX Control Box?
•
Are backup assist lines desired? (the assist lines are on by default)
•
What is the best path to route wires and get the trigger and video signal to the GRAFIX Control Box and
Instrument Cluster?
GRAFIX Trigger Setup
The GRAFIX system is designed so that the implementation of the camera input feature is simple and straightforward.
•
Start with the engine off and the vehicle in park or neutral (if neutral, be sure the wheels are appropriately
blocked/secured)
•
Turn the key to the accessory or on position
•
Tap Control Knob on the Instrument Cluster to bring up the MAIN MENU
o
If there are popup warning boxes in the menu box area, or messages in the Message Areas at this time,
multiple taps may be required to get to the MAIN MENU
o
Any warnings encountered (sensor failures, required calibration, etc.), will need to be cleared before the
user can proceed through to the SETUP section below.
•
Rotate the Control Knob CW until SETUP is highlighted, tap the Control Knob to select
•
A menu list: BLUETOOTH, CLOCK, SPEED, TACH, VOLT, WATER, OIL, FUEL, BIM, WARN, GFORCE,
CAMERA, DEMO MODE, FULL RESET, and BACK will be displayed
•
Rotate the Control Knob to CAMERA, tap the knob to select
•
A sub-menu list will appear in the menu box: TRIGGER and BACK
•
Rotate the knob to highlight the desired item, tap to select
[3]
MAN #650821
Advertisement
Table of Contents
