Table of Contents
Advertisement
m
z
G')
,-
vi
:I:
12
Registering Magic Remote Control
How to register the Magic Remote Control
To
use the Magic Remote, first pair it with your TV.
Put batteries
into
the Magic Remote and turn the TV on.
2 Point the Magic Remote at your TV and press the
([D
Wheel (OK)
on the remote control.
*
If the TV fails to register the Magic Remote, try again after turning the
TV off and back on.
How to deregister the Magic Remote
Control
Press the~ (BACK) and~ (HOME) buttons at the same time, for
five seconds, to unpair the Magic Remote with your TV.
*
Pressing and holding the
~1oe
button will let you cancel and
reregister Magic Remote at the same time.
• Do not mix new batteries with old batteries. This may
cause the batteries to overheat and leak.
• Failure to match the correct polarities of the battery may
cause the battery to burst or leak, resulting in fire, personal
injury, or ambient pollution.
• This apparatus uses batteries. In your community there
might be regulations that require you to dispose of these
batteries properly due to environmental considerations.
Please contact your local authorities for disposal or
recycling information.
• Batteries inside or inside the product shall not be exposed
to excessive heat such as sunshine, fire or the like.
User Guide
For more information about
this
TV, read the USER GUIDE embedded
in
the product.
(Depending
upon model)
• To
open the USER GUIDE@
-
0 (0)
-
[General] -
[About This TV]
- [User
Guide]
Troubleshooting
Cannot control the TV with the remote control.
• Check
if
anything such as tape has been placed over
the
receiver.
• Check
if
there is any obstacle between the product and the remote
control.
• Replace the batteries with new fresh ones.
No image display and no sound is produced.
• Check if the product is turned on.
• Check if the power cord is connected to a wall outlet.
• Check if there is a problem in the wall outlet by connecting other
products.
The TV turns off suddenly.
• Check the power control settings. The power supply may be
interrupted.
• Check if the auto-off function is activated in the settings menu.
• If there is no signal while the TV is on, the TV will tum off
automatically after 15 minutes of inactivity.
Advertisement
Table of Contents
