Advertisement
Quick Links
PULT01 / PULT02
Desk panels for barriers and pedestrian gates
PULT01
Desk panel 1-
channel
The desk panels PULT01 / PULT02 are used for manual control of barriers and / or pedestrian gates, e.g. from a
porter's lodge or from a reception. The 1-channel version PULT01 can control only one barrier or one pedestrian
gate, with PULT02 two independent barriers or pedestrian gates or also a combination of a barrier and a
pedestrian gate can be controlled.
A sheet with standardised sticker symbols is supplied. This can be used to paste over the membrane buttons if
another function is to be switched with it. White blank stickers are also supplied, with which the membrane
buttons can also be labelled using a waterproof pen if required.
Technical data
Characteristic
Number of channels
Power supply,
separate for each
channel
Number of buttons
per channel
Number of inputs per
channel
Number of outputs
per channel
Number of LED per
channel
Dimensions
L x W x H
IP protection
Connection cable
Standards EMC
www.MagneticGateOpeners.com | (800) 878-7829 | Sales@MagneticGateOpeners.com
PULT02
Desk panel 2-
channel
Value
PULT 01 = 1-channel
PULT 02 = 2-channel
24 V DC ± 10 %
4
2 pieces, 24V DC
5 pieces, 24 V DC
5 pieces
165 x 90 x 48 mm
IP 65
10-core, 3 m length
EN61000-6-2
EN61000-6-3
Notice
Reverse polarity protection by diode
2 simple push buttons,
2 push buttons with memory function
Indication of status via LED
Advertisement
Summary of Contents for Magnetic PULT01
- Page 1 The desk panels PULT01 / PULT02 are used for manual control of barriers and / or pedestrian gates, e.g. from a porter's lodge or from a reception. The 1-channel version PULT01 can control only one barrier or one pedestrian gate, with PULT02 two independent barriers or pedestrian gates or also a combination of a barrier and a pedestrian gate can be controlled.
-
Page 2: Control And Display Elements
Control and display elements Button S1: Works like a multi-stage switch. By pressing several times, one of two outputs (OUT1/OUT2) is cyclically switched on, then both outputs are switched off. The associated LEDs P1 and P2 indicate the switching status of the two outputs. - Page 3 Functionality with MHTM™ MicroDrive barriers With a desk panel PULT01, one barrier can be operated, with a PULT02, two barriers can be operated via three separate buttons each. For this, the barriers must be set to either operating mode 4 (two-pulse control) or operating mode 2 (deadman).
- Page 4 The cables can be extended on site using junction boxes if required. Replacement for previous desk panels PG01 to PG04 A desk panel PULT01 or PULT02 can replace an old desk panel PG01 or PG02. If PG03 or PG04 are to be replaced, two panels must be used.
- Page 5 The buttons and the associated LEDs can be assigned individually according to customer requirements. Below you will find a possible example for the use of a desk panel PULT01 / 02 with a mWing. Alternatively, you could also assign the function "Illumination off" or "Inhibit opening" to button S2, for example.