Advertisement
Available languages
Available languages
Thank you for choosing our pallet trucks. For your safety and correct operation, please carefully
read the manual before use.
NOTE:
All of the information reported herein is based on data available at the time of printing.
The factory reserves the right to modify its own products at any time without notice or liability in
any sanctions. Please verify with the factory for possible updates and changes.
1. GENERAL SPECIFICATIONS
Capacity
Maximum
Fork
(mm)
Minimum Fork Height
Fork Length
Width Overall Forks
Individual Fork Width
Load Wheel Diameter (mm)
Steering Wheel Diameter (mm)
Special fork lengths are available in 800, 900, 950, 1000, 1500, 2000 mm.
Materials and specifications are subject to change without notice.
2. ATTACHING HANDLE TO PUMP UNIT
2.1 Remove 3 bolts (D611) from the handle bracket (D151).
2.2 Set handle (D610A, D610B or D610AS) on the bracket (D151), notice to allow the chain (D612)
and the adjusting bolts (D614) assembly to pass through the hole in the center of the bracket
(D151) and shaft (D153).
2.3 Insert the 3 bolts (D611) through the handle into the bracket (D151), then tighten them
securely.
2.4 Raise the lever plat (D132) and insert the adjusting bolt (D614) into the front slot, keeping the
adjusting nut (D615) on the under side of the lever plat (D132).
3. ADJUSTING RELEASE DEVICE
On the draw-bar of this pallet truck, you can find the control handle (D608 or D608S) which can be
adjusted in three positions :
Raise
- handle down
Drive
- handle in center position
Lower
- handle up, the lever moves back the drive position when released.
If however they have been changed, you can adjust according to the following steps:
3.1 If the forks elevate while pumping in the DRIVE position, turn the adjusting nut (D615) on the
adjusting bolt (D614) or adjusting screw (D133) clockwise until pumping action does not raise the
forks and the DRIVE position functions properly.
(kg)
2000
Height
(mm)
(mm)
1150
(mm)
(mm)
Ø 80x70(or Ø 74x70) Nylon, Polyurethane
Ø 200(or Ø 180) Nylon, Polyurethane, Rubber
2000
2500
2500
200(or190)
85(or75)
1220
1150
1220
450 / 520 / 550 / 685
160
1
3000
3000
1150
1220
Advertisement
