Advertisement
Quick Links
Please visit our website for the most current instructions, assembly tips, to report damage
or request parts. www.walkeredison.com
Copyright © 2018, by Walker Edison Furniture Co., LLC, All rights reserved.
Copyright © 2018, by Walker Edison Furniture Co., LLC, All rights reserved.
Item: DAMD3E
Assembly Instructions
Revised
-V-1
08/23
P.1
Advertisement
Related Manuals for Walker Edison DAMD3E
Summary of Contents for Walker Edison DAMD3E
- Page 1 Please visit our website for the most current instructions, assembly tips, to report damage or request parts. www.walkeredison.com Revised -V-1 08/23 Copyright © 2018, by Walker Edison Furniture Co., LLC, All rights reserved. Copyright © 2018, by Walker Edison Furniture Co., LLC, All rights reserved.
-
Page 2: General Assembly Guidelines
General Assembly Guidelines and hammer Copyright © 2018, by Walker Edison Furniture Co., LLC, All rights reserved. -
Page 3: Parts List
Parts List 01 pc Table top 04 pcs 01 pc Extension top 02 pcs Rail... -
Page 4: Hardware List
Hardware List ø10*30mm 02 pcs Wooden dowel ø8*30mm 04 pcs Wooden dowel Screw ø3,5*30mm 06 pcs ø1/4"*70mm Screw 08pcs Hex Key 01 pcs 12mm 08 pcs Washer Hammer recommended Philips head screwdriver required for assembly (not included) for assembly (not included) The hardware quantities listed above are required for proper assembly. - Page 5 Step 1 Fix the legs on the table top with the screws (D) and washers (F) using the Hex key (E), according to the diagram. Hex key ø1/4*70mm Washer Step 2 To extend the table, release the lock under the top, according to the detail and pull the ends.
- Page 6 Step 3 Insert wood dowel (B) into part 4 ø8*30mm Step 4 Pay attention to the side where the wood dowels will be insert Fix the rails on the extension top with the screws (C) using a Phillips Head Screwdriver. Insert wood dowel (A) into part 4.
- Page 7 Step 5 Pay attention Pay attention to the side to the side of the pins of the pins Fix the extension top at the opening. Step 6 After joining the top panel, lock again as detailed above.
- Page 8 Step 7 If necessary, adjust the feet to be level with the floor as shown in the diagram. Step 8 Distributed weight.