1. Manuals
  2. Brands
  3. Lumber Jack Manuals
  4. Cutter
  5. JAWHORSE JH300
  6. Original instructions manual

Lumber Jack JAWHORSE JH300 Original Instructions Manual

Portable clamping station
Hide thumbs
1
2
3
4
5
6
7

Advertisement

Table of Contents

SAFETY AND OPERATING MANUAL
JAWHORSE PORTABLE CLAMPING STATION
JH300
ORIGINAL INSTRUCTIONS
JH300

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the JAWHORSE JH300 and is the answer not in the manual?

Questions and answers

Related Manuals for Lumber Jack JAWHORSE JH300

Summary of Contents for Lumber Jack JAWHORSE JH300

  • Page 1 SAFETY AND OPERATING MANUAL JAWHORSE PORTABLE CLAMPING STATION JH300 ORIGINAL INSTRUCTIONS JH300...

  • Page 2: Parts Diagram

    Parts Diagram 4------ 9------1 ------7 15---- - --- - 8 ---- - 6---­ s---- 1. Moving jaw 9. F ront leg 2. Fixed jaw locking knobs 3. B ody 10. hand knob 4. Lock/ releaseswitch 11. Pull handle 5. F ootpedal 12.

  • Page 3: Before Each Use

    Before Each Use 6WARNING Read and understand the all instruction before operating this tool. • The manufacturer shall not be liable for any changes made to the tool nor for any damage resulting from such changes. SET-UP & PREPARATION Setting up (fig. 1-4) To operate the stand follow the simple set-up instructions.
  • Page 4 Operating Instructions Ensure you are supporting the work piece to prevent it from falling once the jaw is released. When working along the line of thejaws, place your foot on the footplates to prevent it from moving For extra force you may stand on the foot pedal(maximum 22001bs) but do not jump on it, as you could damage the unit.

  • Page 5: Operation

    OPERATION Clamping a workpiece (fig.5-8) 1. Slide the lock/release switch (4) up to the unlock position. Position the sliding jaw (1) away from the fixed jaw (2) to open. Carefully place your workpiece against the fixed jaw(2),while ensuring it will not fall, move the sliding jaw (1) forward by hand until it touches the workpiece.

  • Page 6: After Each Use

    Folding (fig. 13-15) For folding the Stand, carefully place upside down on a flat surface and follow the simple set-up instructions Ensure that: 1. The lock/release switch (4) is up in the unlock position. The foot pedal release (8) is used to release and fold the foot pedal (5).

  • Page 7: Troubleshooting

    Maintenance Interval Maintenance Point Several turns may be necessary on initial set-up until the clamps tighten into place -a half turn is all that is required to release the legs when folding. Daily before operating After each use remove any dirt or debris by wiping down with After the first 20 operating hours a damp clean cloth and allow to dry The pawl carrier pivot pin may require a small amount of...

Table of Contents