JSG A2 User Manual

8
7
1. Lexan Decal
2. Engineered ABS Resin Enclosure
3. LED indication for Power, Pump Status and Fault
4. Enter button for selection

SET UP:

To enter setup mode hold down
the middle button (6) for 5 seconds.
NOTE:
Cursor on left will
flash Menu Mode
In this state the user can scroll up and down through
the various settings options by pressing the up (7) and
down (6) buttons. To adjust the setting, use the enter (4)
button to move the cursor to the right side and select by
moving through options with the up or down buttons.
To accept the change, press the enter button which will
move the small cursor back to the left side as illustrated
in the image above.
Quality Engineered Systems
1
5
6
2
3
4
5. Buzzer on for faults
6. Button to scroll down for selection (Mute)
7. Button to scroll up for selection (Run/Pause)
8. OLED Display

SPECIFICATIONS:

VOLTAGE:

10.5VDC TO 30VDC

CURRENT DRAIN:

15mA MAX (no load) 10mA nominal

PUMP OUTPUT:

12A Continuous,15A
for 15 sec, 20A for 6 Sec

LAMP OUTPUT:

5A MAX

SWITCHING:

Solid state short circuit protected

FUSE:

Electronic Fuse (60A)
TEMPERATURE RANGE:
-30˚C to 60˚C
JSG Industrial Systems
USER GUIDE
A2 CONTROLLER
Run External
Mode Warning
Pause Motor Open
Mode Circuit
System Motor Short
Selection Circuit
Low Blockage
Level Detection
Vent Test
Time Mode
Proxy 1 Proxy 2

CONNECTION:

14 way MOLEX MINIFIT - JR

COMMUNICATIONS:

RS232 Type
BLUE TOOTH:
LE Connection
(Low Energy Interface)
Range > 20m

DIMENSIONS:

95 mm X 78 mm X 38 mm
(including mounting bracket)

WEIGHT:

120g
PROTECTION:
IP54
| www.jsgindustrial.com