Advertisement
18.WRITING IN THE REMOTE CONTROL MEMORY
RAM memories 31 to 90 are user-programmable.
(D Press the "M" memory key.
(2 Use the ten-key numerical
pad to specify
the number of the memory.
This number will
blink on the "MEMORY" display.
(9 Press
the "STR" memory
key.
The specified
data will
be written
into the memory.
19.CHANGING PRE-SET MEMORY DATA
See SECTION IV for information about the "PRESET" group of keys.
When the unit leaves
the factory,
the "PRESET" keys are already set with the data from ROM memories
] to 8.
With the following operation,
the data for any of these keys can be changed at will.
Note that the data which
is set for a "PRESET"
key must already have been set in one of
the user programmable
memories
(see the previous
explanation),
or in one of the memories
of the ROM.
(D Press the "M" memory key.
@ Use the ten-key numerical
pad to specify the number of the memory
(1 to 90) which
holds the data to be pre-set.
This memory number will blink on the "MEMORY" display.
(9 Press one of the "PRESET" keys (1 to 8).
(D Press the "STR" memory key.
The memory display will stop blinking,
and the data
will have been copied
into the pre-set key memory.
Note: The "PRESET" keys recall data set in the RAM,
they are not a separate memory.
If the RAM memory number data is changed,
the "PRESET" key will recall
the changed
data.
So remember to keep track of what data you wish the "PRESET" key to recall,
and don't change it by mistake.
20.DATA MOVING (RAM Back up)
The remote control
can be used
to store 9 different
sets of data
in a RAM
(numbers 91 to
99),
This data can then be transferred
to another REV-] unit by disconnecting
the remote
control
unit,
and connecting
it to that unit.
(D See page 25 for the three steps needed
to read data from a memory.
(2 Use the ten-key numerical
pad to specify
the memory
to be used
to hold
the data,
(91
to 99).
The "MEMORY" display will blink with the specified memory number.
@ Press
the "STR" memory
key,
and the data will be stored
in the memory,
and the
display will stop blinking.
31
Advertisement
